Tissue Paper Cards

I’ve been so busy going to school for the last two years that my crafting adventures have been put on hold. Well, I just finished my internship this week and that means I’m completely done! I’m not ready to jump back into crafting just yet, but I made some cute cards this morning and thought I’d share them with you.

Every time I go to Cost Plus World Market I find the cutest gift wrap. I don’t really need it so I tend to only buy some at Christmas time, even though I’d love to use some as wallpaper someday! Yesterday I just couldn’t resist and bought a pack of tissue paper sheets with a retro travel theme. They had paper, bags, tags, tissue, felt totes, and note cards all in this adorable theme. The note cards were cute but they were all the same image and I just felt like the wrapping paper and tissue had so much fun stuff going on that they would make great cards.

The finished cards!
The finished cards!

It was really easy to make these cards, I bought the tissue paper and everything else I needed was already on hand. I used a cutting mat, x-acto knife, glue stick, blank note cards, glue pen, a metal ruler and a brayer.

Supplies you will need.
Supplies you will need.

First, cut out a piece of the tissue paper so that it has the design you want and is a little bigger than the front of the card. I used a glue stick to apply glue all over the front of the card, then carefully stick down the sheet of tissue paper, let the edges hang over. I smoothed it out with my hand first, then covered the card with the mat or a piece of paper and rolled over it with the brayer. It’s an extra step but it really helps get the tissue nice and flat.

Smooth out the paper with your brayer.
Smooth out the paper with your brayer.

The next step is trimming off the excess edges. Using your metal ruler, line it up with the edge just on top of the edge of the card and slice away the overlapping tissue. Repeat on all four sides! Once you have that done you can use the glue pen to touch up any loose corners that didn’t stick the first time.

Trim the edges to perfectly fit the card.
Trim the edges to perfectly fit the card.

This is a pretty easy craft that I could spend all day doing, there is enough tissue paper to make dozens of super cute cards! You can leave them blank and then rubber stamp the insides for whatever occasion comes up! I think I’ll be doing this again in a few months when it’s time to send out Holiday cards!

I can't get enough of these fun little scenes!
I can’t get enough of these fun little scenes!

 

Advertisements

Decorating Glass Candle Holders

This project started as an idea while shopping at the craft store. I came across two different materials that I wanted to put together. One item is a great set of decorative keys from artist Tim Holtz. The other item was a package of five sheets of tissue paper. This tissue paper is 12 x 12 inches and I found it in the scrapbook section with all of the single sheet papers. As soon as I saw the paper I knew I wanted to make candle holders. I had made one tissue papered candle holder in the past and love how they light up with a nice glow. This particular paper has a nice warm color to it, almost like antique paper. The best part, it’s covered in keys! An all over print in black of many styles of keys lends itself perfectly to being paired with the decorative keys.

Word Keys

To complete my materials list I needed to get some clear glass candle holders. I had seven keys to play with so I wanted to make six holders that could be split up into two sets of three. I went to the Dollar Tree for my largest glass cylinders, these sell at other stores for much more, always check the Dollar Tree! Finding small votive size glass cylinders was also easy and inexpensive. The medium size proved to be a little tricky. I looked lots of places but the glass was either curved or has a decorative bottom or top edge, I couldn’t find a plain cylinder. Finally, I found some drinking glasses that look just like my large and small cylinders. Now for the fun part, papering the glass pieces. I used Mod Podge in matte finish with a foam brush. I painted a few inch wide strip on one side of the glass, top to bottom. I lined up the edge of the paper with the top of the glass and pressed it down. Smooth out the bubble as you go, gluing in smaller sections makes this easy to do. I had wrapped my paper around before gluing to cut it down to size. Leave a small overlap and glue the edge down.

Cover with tissue paper

Now you have a clean top edge but too much paper left on the bottom. Cut strips down to the bottom of the glass. Trim the strips so that they reach about the middle of the bottom when folded over. Give the base a coat of Mod Podge and then one at a time, fold over your strips of paper. You will end up with a nice spiral covering.

Cover the bottom

Once you have papered each holder, give it two coats of Mod Podge, letting it dry between each coat. This will keep the surface in good shape, tissue paper is delicate stuff! When your pieces are dry, I suggest adding a finishing paper to the base. I always like how it looks. I used brown velvet paper and double-sided adhesive sheets that I cut to fit each glass piece.

A nice finished look

With the papering done, it’s time to add the metal keys. I chose to use black paper chord, also from the craft store. I wound it around the top ┬áthree times, added a few inches and cut, do this for all of the glass pieces. I folded the chord in half and tucked it into the hole on the key, creating a loop that would allow the key to hang flat. I used a small dab of hot glue to initially hold the key in place, just behind the paper chord. Wrap the chord around and tie in the back. I used a thin line of Elmer’s white glue around the top of the chord, just to keep it from sliding down. It dries clear, you just need a little bit. The keys will make a clanking sound on the glass, I just put a tiny piece of Glue Dots Line behind each key to hold it flat.

Key details 

Key details

The finished pieces look so great. I took some outdoor pictures as well as some pictures of them lit up. I love how these came out, and I made them all for about $20.00!

Outside in the sunlight
A nice warm glow
Use individually as well

The possibilities are endless with this project. Tissue paper comes in all sorts of colors and patters. With inexpensive glass cylinders, you can make these for every occasion. You can leave off the embellishments and save more money. Try making a bunch next time you need centerpieces for a special event! If you want to make them as wedding favors, use battery operated tea lights. At the end of the night, your guests can take one home! And, without touching warm glass and spilling hot wax everywhere, they will be more than happy to take them. Enjoy!
Skip To My Lou
They are talking about me at CraftGossip.com